Digi 90031300 manual Begin or continue Phase C Receive Data, Begin Phase C Data Transmission

+FDR Begin or continue Phase C Receive Data.

Command syntax: +FDR

This command will initiate a transition to Phase C data reception.

+FDT Begin Phase C Data Transmission.

Command syntax: +FDT

This command prefixes Phase C data transmission.

+FECM Error Correction Mode Control.

Command syntax: +FECM=<value>

0:Error correcting mode disabled.

+FET	Transmit Page Punctuation.
Command syntax: +FET=<ppm>
0:	[PPS-]MPS	Another page next, same document.
1:	[PPS-]EOM	Another document next.
2:	[PPS-]EOP	No more pages or documents.
3:	PPS-NULL	Another partial page next.
4:	[PPS-]PRI-MPS	Another page, procedure interrupt.
5:	[PPS-]PRI-EOM Another document, procedure interrupt.
6:	[PPS-]PRI-EOP	All done, procedure interrupt.
7:	CTC	Continue to correct.

This command is used to punctuate page and document transmission, after one or more +FDT commands.

+FK Session Termination.

Command syntax: +FK

This command causes the modem to terminate the session in an orderly manner.

+FLID Local ID String.

Command syntax: +FLID=”<local ID string>”

Valid values: ASCII string can be up to 20 characters.

Response syntax: +FLID=?

Return value: (20), (32-127)

+FLNFC Page Length Format Conversion.

Command syntax: +FLNFC=<value>

0:Disables mismatch checking. The DTE must check the +FDCS:LN subparameter, and transfer matching data.

+FLPL Indicate Document to Poll.

Command syntax: +FLPL=<value>

0:Indicates that the DTE has no document to poll.

+FMDL Request Model Identification.

Command syntax: +FMDL?

Response value: The information text cannot exceed 2048 characters.

This command causes the modem to send one or more lines of information text which is used to identify the product.

Appendix F 125