Planning Worksheets

The T1 Modem Bank must be configured to match the provisioning of the T1 line from the carrier.

General Information

Required information includes the following:

The identity of the WAN manager for your local and remote sites

The identification of the TELCO providing the WAN

Table 3

Requirements for T1 Modem Bank Setup

Requirements

Description

Location of the T1 Modem

The T1 Modem Bank must be positioned where it can be connected to the WAN

Bank

within the specified cable limits.

Active T1 line

One or more active and installed T1 lines from the WAN service with at least two

 

channels assigned.

Ground Start or Loop Start

CSU supervision mode

Circuit ID

Identifier used by the T1 provider to refer to the line. It refers only to the T1 line and

 

is not associated with individual phone numbers. You must keep track of the circuit

 

ID number for each line, since if you experience trouble on the T1 line, the service

 

provider will need to know this number.

You can make as many copies as you need of the worksheet on the following page. A copy of this worksheet should also be filled out for both the local and remote sites.

6

T1 Modem Bank

Page 16
Image 16
Digi 90031300 manual Planning Worksheets, General Information, Requirements for T1 Modem Bank Setup