Edirol UA-20 New Hardware, Found dialog box will appear, SetupInf dialog box, and click OK

Getting Connected and Installing Drivers (Windows)

8

Use the USB cable to connect the UA-20 to your computer.

9

If you are using

Windows 98, an

Insert disk

dialog box will appear.

Click [OK].

10

The New Hardware

Found dialog box will appear.

In the Copy files from field, type the folder name that is shown in the

SetupInf dialog box, and click [OK].

D:\DRIVER\USB_ME98

*The drive name “D:” may be different depending on your system. Type the name of your CD-ROM drive.

11

Once the driver has been installed, the New Hardware Found dialog box will close.

In the SetupInf dialog box, click [OK]. The SetupInf dialog box will close.

Next, you need to make the driver settings. (➝ Settings and checking (p. 36))

This unit is equipped with a protection circuit. A brief interval (a few seconds) after connecting a USB connector is required before the unit will operate normally.

If you are using Windows 98 and the Insert disk dialog box dose not appear, please read

The “Insert Disk” dialog box does not appear (p. 68).

If the New Hardware Found dialog box does not appear, re- install the driver using the same procedure as described in The “Insert Disk” dialog

box does not appear (p. 68).

30