Edirol Installing the OS-standard driver, Place the UA-20’s Advance mode select switch

Getting Connected and Installing Drivers (Windows)

Installing the OS-standard driver

The procedure for installation and settings will depend on your system.

Proceed to the appropriate section as follows.

•Windows XP/2000 users ...................(p. 31)

•Windows Me users .............................(p. 32)

•Windows 98 users...............................(p. 33)

■Windows XP/2000 users

1

With the UA-20 disconnected, start up Windows.

Disconnect all USB cables except for a USB keyboard and USB mouse (if used).

2

Exit all currently running software (applications).

If you are using a virus checker or similar software, be sure to exit it as well.

3
Place the UA-20’sADVANCE (mode select) switch
in the OFF position.
4
Use the USB cable to connect the UA-20 to your
computer.	If you are using Windows XP,
The UA-20 will be detected automatically, and the driver will	the installation has been
	completed when the message
be installed.
	near the taskbar saying that
	“Found New Hardware” has
5	disappeared.
When installation is complete, restart Windows.
Next, you will need to make the driver settings.	This unit is equipped with a
(➝ Settings and checking (p. 36))	protection circuit. A brief
	interval (a few seconds) after
	connecting a USB connector is
	required before the unit will
	operate normally.

English

Deutsch

Français

Italiano

Español

31