Edirol UA-20 Windows Me users, New Hardware Wizard, Make sure that Automatic, Click Finish

Getting Connected and Installing Drivers (Windows)

■Windows Me users

1

With the UA-20 disconnected, start up Windows.

Disconnect all USB cables except for a USB keyboard and USB mouse (if used).

2

Exit all currently running software (applications).

If you are using a virus checker or similar software, be sure to exit it as well.

3

Place the UA-20’sADVANCE (mode select) switch in the OFF position.

4

Use a USB cable to connect the UA-20 to your computer.

5

Windows will detect the

UA-20, and the “Add

New Hardware Wizard”

dialog box will appear.

Make sure that Automatic

search for a better driver (Recommended) is selected, and

click [Next].

6

Driver detection will begin.

7

When the driver has been found, driver installation will begin.

8

Once the driver has been installed, a dialog box will inform you of this.

Click [Finish].

This unit is equipped with a protection circuit. A brief interval (a few seconds) after connecting a USB connector is required before the unit will operate normally.

Depending on your system, a certain amount of time may be required for the device to be detected after the driver has been installed.

32