Edirol UA-20 owner manual OMS settings, Driver E-OMS Driver

Getting Connected and Installing Drivers (Macintosh)

OMS settings

To check the OMS settings, you will first need to connect a MIDI sound module to the UA-20's MIDI OUT connector. For details on connecting a MIDI sound module, refer to the owner's manual for your MIDI sound module.

1

Set the UA-20’sADVANCE (mode select) switch to the ON position.

2

Use the USB cable to connect the UA-20 to your computer.

3

From the CD-ROM, drag the

Driver E–OMS Driver–

Settings folder into the Opcode–OMSfolder on the hard disk of your Macintosh to copy it there.

4

In the Opcode-OMS Application folder where you installed OMS, double-clickOMS Setup to start it up.

5

If a dialog box like the one shown here appears, click [Turn It Off]. A confirmation dialog box will then appear, so click [OK].

This unit is equipped with a protection circuit. A brief interval (a few seconds) after connecting a USB connector is required before the unit will operate normally.

English

Deutsch

Français

Italiano

Español

45