Safety Notes
As soon as you modify the product or change the default configuration you are responsible for complying with all relevant regulatory standards.
VCCI
This is a Class B product based on the standard of the Voluntary Control Council for Interference by Information Technology Interference (VCCI). If this equipment is used in a domestic environment, radio disturbance can arise. When such trouble occurs, the user is required to take corrective actions.
Installation
Damage of Circuits
Electrostatic discharge and incorrect installation and removal of the product can damage circuits or shorten their life.
Before touching the product make sure that your are working in an
System Damage
To avoid system damage verify that the system environment meets the environmental and power requirements given in this manual before installing the system.
Before you begin to set up and cable your new system, consider these guidelines:
zRestricted access area: Install the system only in a restricted access area.
zInstallation codes: This unit must be installed in accordance with the National Electrical Code, Articles 11016, 11017, and 11018 and the Canadian Electrical Code, Section 12.
zOvercurrent protection: A readily accessible listed branch circuit overcurrent protective device must be incorporated into the building wiring. For appropriate AWG rating of the overcurrent protection device see NEC Table 31016 and other national regulations.
zThe protective bonding conductor depends on your power distribution topology. Make sure that you use an appropriate protective bonding conductor regarding the rating of the branch circuit protection.
111 |
