Emerson Process Management 3-9000-745 manual Editing integration events

User Manual	MON20/20 Software for Gas Chromatographs
3-9000-745	SEPTEMBER 2010

The following table describes the valve-related parameters that are available on the timed events window.

Parameter	Description
TEV Type	The type of event. You have the following choices:
	•	Valve # - A valve.
	•	DO # - A discrete output.
	•	Strm Sw - Switches to the next stream in the sequence.
	•	FID Gain - Sets the FID to high or low gain.
	•	FID Auto Zero - Zeros the FID preamp after a gain change.
Valve/DO #	Use the drop-down menu to select the specific valve or discrete output that should be
	used for the event.
	This column does not apply if Strm Sw, FID Gain or FID Auto Zero was selected from
	the TEV Type column.
State	Turns the valve or discrete output on or off, or sets the FID to high or low.
	This column does not apply if Strm Sw or FID Auto Zero was selected from the TEV
	Type column.
Time	Indicates the time, in seconds, that the event should occur during the analysis. Enter a
	value between 0.0 and 3600.0.
	NOTE: Event times must be less than the analysis time.

4.3.2 Editing integration events

Integration-related events are grouped on the upper right side of the Timed Events window. To edit integration-related events, do the following:

1.Select Timed Events... from the Application menu. The Timed Events Tables selector window appears, displaying a list of available timed events tables.

4-22