User Manual MON20/20 Software for Gas Chromatographs
3-9000-745 SEPTEMBER 2010
6-2
Figure 6-2. Confirmation message
3. Click Yes and the analysis will stop at the end of the current cycle.
Use the Mode column on the GC Status Bar to monitor the status of
the operation. When the analysis has halted, the Mode value will be
“Idle”.
Figure 6-3. The GC Status Bar
6.2 Auto sequencing
Use this function to start continuous GC analysis runs that follow a
predefined stream sequence. See “Creating a stream sequence for a
detector” on page 4-78 for detailed instructions on configuring the
predefined sequence.
Note
If an analysis run is in progress, it must be stopped before auto sequencing can be
started. See “Stopping an Analysis Run” on page 6-9 for more information.