EnGenius Technologies EOC5611P specs

6.Press Management VLAN to configure wired VID. Enter your desire VLAN ID and press Apply to configure the changes.

Auction: After press Apply, you must configure your Layer2 Switch or RADIUS Server with the same VLAN ID. Otherwise,

you cannot access to the device’s web-base configuration page.

7. For 802.1x authentication, you may construct your network as below diagram.

Note: EnGenius product supports maximum 4 different SSID with different VLAN ID.

67

Image 68

EnGenius Technologies EOC5611P user manual

Contents

EOC5611P Table of Contents Network Configuration Example Feature Product Overview Wireless extensions to Ethernet networks Wired LAN backupTraining/Educational facilities Fully support all types of security types Benefits Hardware Overview Package ContentsSystem Requirement Red Bad Quality EOC5611P Multi-Function Instruction Guide Access Point Access Point with WDS Function Client Bridge WDS Bridge Client Router Computer Settings Assign a Static IP Logging Method Page Wireless Settings Access Point Mode → Wireless Network Wireless Security Save / CancelSuppressed Ssid Station Separation Client Bridge Mode → Wireless Network WDS Bridge Mode → Wireless Network MAC Address Client Router Mode → Wireless Network Wireless Security Settings 1 WEP WPA-PSK 3 WPA2-PSK WPA-PSK Mixed 5 WPA Radius ServerRadius Port Radius Secret 6 WPA2 WPA Mixed Wireless → Wireless Advanced Settings Radius Accounting Transmit Power Protection ModeWireless Traffic Shaping Data Rate Wireless → Wireless MAC Filter ACL ModeMAC Address Filter Add Wireless → WDS Link Settings LAN Settings System → IP Settings System → Spanning Tree Settings WAN Settings → Static IP Router SettingsRouter → WAN Settings Internet Connection Type Account NameDomain Name IP Subnet MaskPage Use These DNS Servers WAN Settings → Dhcp Dynamic IPGet Automatically From Apply / Cancel WAN Settings → PPPoE Point-to-Point Protocol over Ethernet LoginPassword Service Name Connect on Demand Keep Alive WAN Settings → Pptp Point-to-Point Tunneling Protocol Pptp Server Username Router → LAN Settings Router → VPN Pass Through Pptp Pass ThroughL2TP Pass Through IPSec Pass Through Router → Port Forwarding Add EntryProtocol Starting Port Information Status Status → MainPage Status → Wireless Client List Status → System Log Status → WDS Link Status Status → Connection Status Status → Dhcp Client Table Management Settings Management → AdministrationConfirm Password Name Port Remote UpgradeRemote Management Management → Management Vlan Management Vlan ID Management → Snmp Settings Management → Backup/Restore Settings Management → Firmware Upgrade Automatically Get Date Management → Time SettingsManually Set Date Time Management → Log SyslogLog Server IP Address Local Log Management → Diagnostics Network Configuration Example Access Point Client Bridge Mode WDS Bridge Mode WDS Bridge Client Router Vlan Configuration Guide Page Page Page Appendix a FCC Interference Statement Federal Communication Commission Interference Statement