3.When the Press <Del> to start SETUP prompt appears, press @@.
4.Highlight fun SETUP and press [En(wl. You see the SETUP menu.
Follow the instructions in Chapter 2 of the Setup Guide to either set a new password or select Not Installed (if you do
not want to set a new password). Be sure to save your SETUP information when you exit the program.
5.Turn off the computer and follow the instructions under “Changing the Jumper Settings” in Chapter 4 to enable the password function by setting jumper J3 to position B.
6.If you do not have a hard disk, insert the system diskette in drive A. Turn on the computer.
If you set a new password, you see the Enter Password prompt. Enter the password to access your system. (See “Using the Password” in Chapter 1.)
If you did not set a new password, you do not see the Enter Password prompt and you can access your system immediately.
Note
Be sure to remember your new password or write it down and keep it in a safe place. If you forget the password you enter now, you may have to repeat the above procedure the next time you reboot your computer.
Troubleshooting