4. To insert the SIMM into the socket, press it down firmly into the slot. At the same time, raise the SIMM to stand upright, as shown below.
The SIMM should snap into place between the metal tabs, and the posts should extend through the holes at both ends. If it does not go in smoothly, do not force it; pull it all the way out and try again.
5. Repeat steps 3 and 4 for each SIMM you want to install.
6. Replace the subassembly and cover as described in Chapter 3.
7. Then see “Post-installation Setup” at the end of this chapter for instructions on configuring your computer for use with your new memory.
Installing and Removing Options