Note

If you are removing one hard disk drive and leaving one in your computer, be sure to set the jumpers on the remaining drive to indicate that you have only one hard disk drive. See the table above for the jumper settings. Then follow the instructions under “Removing a Hard Disk From the Vertical Position” on page 5-17 so you can access the jumpers on the drive.

Installing a Hard Disk in the Vertical Position

Follow the instructions in this section to install (or reinstall) a hard disk drive in the vertical mounting position. You may need to perform the following procedures:

Q Remove the mounting frames from a new hard disk drive

Li Remove the mounting plate from the computer and connect it to the drive

P Install the drive

0 Connect the drive and power cables.

If you are installing a new drive in the vertical mounting position, you should follow all the steps in this section. If you are reinstalling a drive that you previously removed from this position, skip to “Installing the Drive” on page 5-11.

Installing and Removing Drives 5-7