Removing a Math Coprocessor
If you need to remove a math coprocessor from your computer, contact your dealer for assistance. You need a special extracting tool to remove the coprocessor without damaging it. Do not attempt to remove it without this tool; you can easily damage it.
Follow the steps in Chapter 3 to remove the computer’s cover and subassembly. Then remove the coprocessor with the tool and replace the subassembly and the cover.
After you remove the coprocessor, run the SETUP program to configure your system for use without it. See Chapter 2 of the Setup Guide for instructions.
Post-installation Setup for Memory Curds
After you install an optional memory card, you need to configure your computer to use it. Follow these guidelines:
0Run the SETUP program to reset your computer’s configuration to include the memory on your memory card. See Chapter 2 of the Setup Guide for instructions.
QUse the setup program that comes with your memory card to configure the computer for use with your particular card. See your memory card manual for instructions.
DIf you installed the RampagePlus® 286+ memory card, follow the instructions in “Using the CORFIX Program,” below, before you install the RampagePlus software.
Also see