Epson FX-880 Default-settingmode, Skip over perforation, 5-4 Changing Printer Settings From the Printer’s Control Panel

Default-setting mode 1

Setting	Options
Skip over perforation	Off, On
Auto tear-off	Off, On
Auto line feed	Off, On
Print direction	Bi-D, Uni-D
Software	ESC/P, IBM 2380 Plus for FX-880,
	IBM 2381 Plus for FX-1180
I/F (interface) mode	Auto, Parallel, Optional
Auto I/F (interface) wait time	10 seconds, 30 seconds
0 slash	0, 0
High speed draft	Off, On(10 cpi), On(12 cpi)
Input buffer	Off, On
Buzzer	Off, On
Auto CR (carriage return)*	Off, On
IBM character table*	Table 2, Table1

*This setting is available only in IBM 2380/2381 Plus emulation mode (IBM 2380 Plus for FX-880, IBM 2381 Plus for FX-1180).

Skip over perforation

This feature is available only when continuous paper is selected. When you turn on this feature, the printer provides a one-inch (25.4 mm) margin between the last line printed on one page and the first line printed on the next page. Because most application program margin settings override margin settings from the control panel, you should use this setting only if you cannot set your top and bottom margins using your application.

5-4Changing Printer Settings From the Printer’s Control Panel