10.After you finish printing, follow the steps in the next section to remove your printed document.

If the first line on your page appears too high or low, you can change its position using the micro adjust feature as described in “Adjusting the Top-of-Form Position” on page 3-35.

Caution:

c Never use the knob to adjust the top-of-form position; this may damage the printer or cause it to lose the top-of-form position.

Removing the printed document from the rear push tractor

To remove the printed document, follow the steps below.

1.Press the Tear Off/Bin button to feed the paper’s perforation to the tear-off edge of the printer cover.

Note:

If your paper’s perforation is not properly aligned with the tear-off edge, you can adjust the tear-off position using the micro adjust feature. See “Adjusting the tear-off position” on page 3-38.

2.Tear off the printed document using the tear-off edge of the printer cover.

3.To feed the continuous paper backward out of the printer and into the standby position, press the Load/Eject button.

To remove the remaining paper from the printer, press the Load/Eject button to feed the paper backward to the standby position. Then open the sprocket covers of the tractor and remove the paper.

3-18Printing on Continuous Paper