Your printer loads the continuous paper automatically when you begin printing.Adjusting the Top-of-Form Position

The top-of-form position is the position on the page where the printer starts printing. If your printing appears too high or low 3 on the page, you can use the micro adjust feature to adjust the top-of-form position. Follow the steps below.

Caution:

c Never use the knob to adjust the top-of-form position; this may damage the printer or cause it to lose the top-of-form position.

Note:

oYour top-of-form position setting remains in effect until you change it, even if you turn off the printer.

oThe top margin setting made in some application software overrides the top-of-form position setting you make with the micro adjust feature. If necessary, adjust the top-of-form position in your software.

1.Make sure the printer is turned on.

2.Load paper. (If the tractor is in a push position, press the Load/Eject button to advance continuous paper to the current top-of-form position.) If necessary, lift up the printer cover so you can see the paper position.

3.Hold down the Pause button for about three seconds. The Pause light starts flashing and the printer enters the micro adjust mode.

Printing on Continuous Paper

3-35