Aligning Vertical Lines in Your Printout

If you notice that the vertical lines in your printout are not properly aligned, you can use the printer’s bidirectional adjustment mode to correct this problem.

During bidirectional adjustment, the printer prints three sheets of alignment patterns, labeled High Speed Draft, Draft, and NLQ (near letter quality). As described below, you select the best alignment pattern from each sheet.

Note:

qTo print the instruction sheet and alignment patterns, you need four single sheets or four pages of continuous paper of at least the following sizes:

Paper type

FX-880

FX-1180

 

 

 

continuous paper

241 × 279 mm

376 × 279 mm

 

(9.5 × 11 inches)

(14.8 × 11 inches)

 

 

 

single sheet

A4 or letter size

A3 landscape

 

 

 

qIf you use single sheets, you need to load a new sheet of paper each time the printer ejects a printed sheet from the paper guide.

Follow these steps to perform the bidirectional adjustment:

1. Make sure paper is loaded, then turn off the printer.

Caution:

c Whenever you turn off the pirnter, wait at least five seconds before turning it back on; otherwise you may damage the printer.

2.While holding down the Pause button, press the Operate button to turn on the printer. The printer enters the bidirectional adjustment mode and then prints instructions and the first set of alignment patterns.

7-14Troubleshooting