3.Press up the tabs on both sides of the paper tension unit and lift it up

and off the printer. If a tractor is installed in the pull position, remove

A

it as described on “Removing the pull tractor” on page 2-31.Store any

printer parts you remove in a safe place.

 

4.Hold the cut-sheet feeder in both hands and fit the feeder’s notches over the mounting posts on the printer as shown below. Then release the latch levers and lower the cut-sheet feeder until it rests on the printer.

5.Insert the cable into the connector as shown above.

6.Replace the printer cover.

You are now ready to load paper in the cut-sheet feeder. To load paper in the high-capacity cut-sheet feeder, see the next section. To load paper in the second bin of the double-bin cut-sheet feeder, see the manual that comes with the second-bin cut-sheet feeder. If you installed the double-bin cut- sheet feeder, you need to select the paper source (bin 1 or bin 2) as described on “Selecting the paper source (bin 1 or bin 2)” on page A-10.

To remove the cut-sheet feeder, reverse the steps above.

Enhancing Your Printer With Options A-5