You are now ready to load continuous paper onto the pull tractor as described in the next section. To remove the pull tractor, see “Removing the pull tractor” on page 2-31.

Loading paper onto the pull tractor

2

 

 

When using the pull tractor, load continuous paper in the front or bottom slot, if possible; loading paper in the rear slot may increase the chance of a paper jam.

cCaution:

Do not load continuous paper with labels in the rear paper slot; the labels may come off their backing sheet inside the printer and cause a paper jam.

To load paper onto the pull tractor, follow these steps:

1.Make sure the printer is turned off, and the printer cover is removed. Also check that the tractor is installed in the pull position.

2.Slide the edge guides to the middle of the paper guide. Lift the center section of the paper guide up and lay it flat.

3.Set the paper release lever to the pull tractor position. Set the paper thickness lever to the proper position for your paper’s thickness.

Printing on Continuous Paper 2-23