❏If you use an extension cord with the printer, make sure the total ampere rating of all devices plugged into the extension cord does not exceed the cord’s ampere rating. Also, make sure the total of all devices plugged into the wall outlet does not exceed the wall outlet’s ampere rating.

❏Unplug the printer before cleaning, and clean it with a damp cloth only.

❏Do not spill liquid on the printer.

❏Except as specifically explained in this guide, do not attempt to service the printer yourself.

❏Unplug the printer and refer servicing to qualified personnel under the following conditions:

If the power cord or plug is damaged; if liquid has entered the printer; if the printer has been dropped or the cabinet damaged; or if the printer does not operate normally or exhibits a distinct change in performance. Adjust only those controls that are covered by the operating instructions.

❏

Printer parts marked with this symbol may be hot.

 

K Turn off the printer and let it cool for a few minutes

 

before you touch any printer part marked with this

 

symbol.

❏If you plan to use the printer in Germany, observe the following:

To provide adequate short-circuit protection and over- current protection for this printer, the building installation must be protected by a 16 Amp circuit breaker.

Note for German-speaking users:

Bei Anschluß des Druckers an die Stromversorgung muß sichergestellt werden, daß die Gebäudeinstallation mit einem 16 A-Überstromschalter abgesichert ist.

Getting to Know Your Printer 11