To adjust the top-of-form position for continuous paper loaded on the pull tractor, see the following example:

First mark a point 6.5 mm (0.26 inches) above the paper’s perforation; then position the paper so that the mark is even with the top edge of the plastic ribbon cover. This gives you 2 an 8.5 mm (0.33 inches) margin on the next page, meaning the printer starts printing 8.5 mm (0.33 inches) below the perforation. If you mark a point 5.5 mm (0.22 inches) above

the perforation, you get a 9.5 mm (0.37inches) margin on the next page.

6.After you set the top-of-form position, press the Pause button to exit micro adjust mode.

Printing on Continuous Paper 2-41