Confidential
EPSON
TITLE SHEET
REVISION NO
SHEETNEXT
20 19
TM-T81
Specification
(STANDARD) A
4) Drawer open/close signal
Input signal level (connector pin 3): "L" = 0 to 0.8 V
"H" = 2 to 5 V
Drawer kick-out connector
1
2
3
4
5
6
F. G
P-GND
P-GND
A
B
Printer side User side (Drawer kick-out side)
+24V
With shielded
Drawer kick-out solenoid
Drawer open/close switch
Figure 2.2.4 Drawer Circuitry
NOTES: 1. Use a shielded cable for the drawer connector c abl e.
2. Two driver transistors cannot be energized simul taneously.
3. The drawer drive duty must be as shown below.
ON time
(ON time + OFF time) 0.2
4. Be sure to use the printer power supply (connector pin 4) for the dr awer power source.
5. The resistance of the drawer kick-out solenoid m ust not be less than the specified.
Otherwise, an overcurrent could damage the solenoi d.
6. Do not connect telecommunicati on net work to the drawer kick-out connector.