Confidential
EPSON
TITLE SHEET
REVISION
NO
SHEETNEXT
40 39
TM-T81
Specification
(STANDARD) A
2) DIP switch 2: 8 switches
Table 3.3.3 DI P S w itch 2
SW 2 Function ON OFF Factory
setting
1 Handshaking (BUSY condition) • Receive buffer full • Offline
• Receive buffer full
OFF
2 Reserved (Do not change settings) --- Fixed to OFF OFF
3 OFF
4
Selects print density See Table 3. 3.4.
OFF
5 Setting the release condition of the
receive buffer BUSY state (t his
function is effectiv e when the
capacity of the receive buf fer is set
to 4 KB.)
Releases the BUSY
state when the
remaining capacity
of the receive buffer
reaches 138 bytes.
Releases the BUSY
state when the
remaining capacity
of the receive buffer
reaches 256 bytes.
OFF
6 Reserved (Do not change settings) --- Fixed to Off OFF
7 I/F pin 6 reset signal (*1) Enabled Disabled OFF
8 IF pin 25 reset signal (*2) Enabled Disabled OFF
Table 3.3.4 DI P S w itch 2-3 and 2-4
Switch No.
3 4 Function
OFF OFF Print density (Standard)
ON OF F Print density (Medium)
OFF ON Print density (Dark)
ON O N Pri nt density (Standard)
NOTES: 1. Change the DIP switch when the printer power is turned off.
2. Changes in DIP switch settings are recogni zed only when the printer power is turned on
or when the printer is reset by using the interface. If the DIP switch setting i s changed
after the printer power is turned on, the change does not take ef fect until the printer is
turned on again or is reset.
3. If the print density is set to “medium”/”dark” lev el, printing speed is inclined to be low
speed.