Start the Phone – Log On/Off

Start the Phone

Startup procedure

All the system settings for your IP phone must be set by the system administrator before you can use the phone.

Connect the phone to the local network.

See the Installation section, “Install Cables” on page 110.

Note: Depending on the settings in your network and telephone system, the start up procedure may be different from phone to phone. Check the display on your phone and read the required sections in this chapter to continue with the start up procedure.

When the phone is connected to the network, your phone automatically initiates the startup procedure when connected to the mains.

Notes: The phone does not work when a power failure occurs.After a power failure the phone will automatically restart. After a power failure the Call List is cleared.

When the telephone is starting up (booting) a connected PC will loose it’s network connection for about 10 seconds.

BusinessPhone – Ericsson Dialog 4422 IP Office

17

Page 17
Image 17
Ericsson 4422 manual Start the Phone Startup procedure, Connect the phone to the local network