SIS Programming
and Control
This section provides instructions on using the Extron Simple Instruction Set (SIS) commands, which you can use to set up and control the IPL T PCS4 from a host computer or other control system attached to the rear panel LAN port. The following topics are discussed:
•
•Using the Command and Response Table
•Symbol Definitions
•Command and Response Table for SIS Commands
As shipped, the PCS4 works as a standalone interface, but cannot control any other devices until it is configured. You can set up and control the PCS4 by using the front panel, the web pages, or SIS commands. Both the web pages and the SIS methods are accessed via Ethernet LAN connection. The LAN port defaults are:
IPL T PCS4 IP address: | 192.168.254.254 |
Gateway IP address: | 0.0.0.0 |
Subnet mask: | 255.255.0.0 |
DHCP: | Off |
Host-to-Interface Communication
SIS commands consist of one or more characters per field. No special characters are required to begin or end a command sequence. When the PCS4 determines that a command is valid, it executes the command and sends a response to the host device. All responses from the interface to the host end with a carriage return and a line feed (CR/LF = ]), which signals the end of the response character string. (A string is one or more characters.)
Messages Initiated by the IPL T PCS4
When a local event such as a front panel selection or adjustment takes place, the PCS4 responds by sending a message to the host. No response is required from the host. The following
© Copyright 20nn, Extron Electronics, IPL T PCS4 [or
Www, DD Mmm 2011 HH:MM:SS]
The PCS4 sends the boot and copyright messages when it first powers on and is connected via Telnet or TCP/IP. Vn.nn is the firmware version number;
IPL T PCS4 • SIS Programming and Control 43
