Extron electronic IPL T PCS4i manual Front Panel Features Operation

Front Panel

Features and

Operation

This section contains a description of the IPL T PCS4 and IPL T PCS4i front panel features and instructions for setting up the PCS4 using the front panel. The following topics are discussed:

•Front Panel Features

•Setting Up the System Using the Front Panel

•Resetting the Unit

Front Panel Features

7 6 7 6 7 6 7 6

	IPL T PCS4			4
	1	2	3
1	F	F	F	F
	R
	S	S	S	S
	2		3

SET REFERENCE

STANDBY FULL

100
LINK	5
ACT

4

Figure 7. IPL T PCS4 and IPL T PCS4i Front Panel

APower LED (green) — When this LED is lit, the PCS4 or PCS4i power control interface is receiving power and is running. When the unit is being reset, this LED blinks the appropriate number of times to indicate the reset mode that has been entered.

BReset button (recessed) — Use the tip of a Phillips screwdriver or a pointed stylus to press this recessed button to reset the unit in one of four Reset modes (see “Resetting the Unit” for details on reset modes and on using this button).

CPower control buttons 1-4— Press these buttons to switch power on and off to the output receptacle with the corresponding number on the rear panel. These buttons are

also used, along with the Set Reference buttons (D), to set the Full and Standby power thresholds.

DSet Reference (Power threshold) buttons — Press these buttons to set the indicator

LEDs for each receptacle to indicate whether the attached devices are operating at Full or Standby power level.

IPL T PCS4 • Front Panel Features and Operation 8