Extron electronic manual Installing labels in the System 7SC’s buttons

Installation, cont’d

Each button label can contain from 1 to 3 lines of text (or none) with choices for each line of different font sizes and whether to center or left justify the text.

Each button label can also contain a picture (or none) selected either from the Device Palette or a user-supplied graphic file. User-supplied graphics should be icon (.ICO) or bitmap (.BMP) files. Files

SCP 250 button label screencalled TEST.BMP and DEMO_BTN.DAT are installed

with this program as examples, and a help file is also included.

Installing labels in the System 7SC’s buttons

Label installation for the SCPs is covered in the SCP/AAP A, SCP 200, SCP 250 User’s Manual. Use the following procedure to install new labels in the System 7SC’s front panel buttons.

1. Remove the button from the switcher: grasp the button firmly and pull it away from the front panel.

2.Separate the gray backing from the clear plastic cap by inserting a flat blade screwdriver into the slots and twisting

it, as shown at right. Screwdriver

3. Save the translucent, white backing plate, but remove the text insert.

4.Make new labels by using the Button-Label Generator software (see pages 2-14 and 2-15). Print and cut them out.

5. Insert a button label and the white backing plate into the cap and reassemble the button. Press the cap onto

the gray backing gently but firmly.

6. Press the button into place in the switcher.

2-16 System 7SC • Installation