Switcher Setup/Configuration
The flowchart below provides an overview of the Switcher Setup/Configuration submenu and the options for each setting.
Extron
System 7SC
MENU
SWITCHER SETUP/ CONFIGURATION
NEXT 
Scaler Rate
1280X1024, 60 Hz
NEXT 
Scaler Sync
RGsB
NEXT 
Scaler Polarity
H+/V+
NEXT
Scaler output rates
•See the table on the next page for available combinations of resolutions and refresh rates.
Default: 640x480, 60 Hz
NOTE Lock =
Sync formats | Polarity combinations | |||
• RGBHV (default) | • | • | H+/V- | |
• RGBS | • | • | H+/V+ | |
• RGsB |
|
|
|
|
RGB Delay
1.5 Sec.
Delay time (in seconds)
•0.0 (default) up to
•5.0
in 0.5 sec. increments
NEXT 
Scaler Blue Out?
(No) Yes
Display blue & sync only
•No (default)
•Yes
NEXT 
Edge Smoothing?
No (Yes)
Smooth edges
•No
•Yes (default)
NEXT
Add Slave
No Slave Swr
NEXT 
Autoselect # 07
No (Yes)
NEXT 
Room1 Relay Cnfg
Toggle On/Off
NEXT
Add a slave switcher on input 1
• No Slave Swr (default)
...or select a slave switcher input quantity:
•8 Input Slave
•10 Input Slave
•6 Input Slave
•4 Input Slave
Autoselect the input signal format for the front panel input
•No
•Yes (default)
RGB input has priority over
Configure the Room 1 relay
•Toggle On/Off (default) – Latching mode. The relay remains open or closed until the button is pressed again.
•X.XXX Sec – Momentary mode. The relay is open or closed for a set time, adjustable from 0.250 seconds to 2.000 seconds in 0.125 second increments.
Room2 Relay Cnfg |
| NEXT |
1.375 Sec |
| |
|
| |
|
|
|
Configure the Room 2 relay
•Toggle On/Off (default) – Latching mode. The relay remains open or closed until the button is pressed again.
•X.XXX Sec – Momentary mode. The relay is open or closed for a set time, adjustable from 0.250 seconds to 2.000 seconds in 0.125 second increments.
2:2 Pulldown |
| NEXT |
Input#01 : Off |
| |
|
| |
|
|
|
Turn 2:2 Pulldown On/Off (per input)
•On – Select this to activate 2:2 film detection for the selected input to maximize image detail and sharpness for for PAL source material that originated from film.
•Off (default) – 2:2 detection is off.
If you press the Menu button while a submenu is active, the next main menu will become active. For example, the menu will change from the Switcher Setup/Configuration menu or submenus to the Audio/Video Adjustments main menu.
To return to the default screens, let the System 7SC
System 7SC • Operation and Configuration |
