Audio Level

From this submenu audio levels can be adjusted per input from -15 dB to +9 dB in

0.5dB increments. This allows the signal to be boosted or trimmed to a consistent output level so that there is no noticeable difference in level when switching between inputs. This adjustment applies to both the Fixed and the Variable audio output.

The Volume adjustment, which affects the Variable audio output only, is applied to all inputs equally, and it is an attenuation applied in addition to the per-input audio level adjustments made using this submenu.

Blank Input (blanking adjustment)

To remove noise or extraneous material such as closed captioning by removing scan lines at either the top or bottom of the screen, adjust the top blanking or bottom blanking. Rotate the vertical shift knob to set the number of lines removed from top of the picture. Rotate the horizontal shift knob to set the number of lines removed from the bottom.

Image Size

To proportionately resize the displayed picture without altering the aspect ratio, rotate either the vertical () or the horizontal () shift knob while in the Image Size submenu. Whichever knob is used, the effect is the same: proportional picture sizing.

During Image Size adjustment, if a horizontal or a vertical size limit is reached, the sizing stops, and the aspect ratio remains unchanged. The LCD screen displays Min or Max.

Size Input

To resize a picture, enter the Size submenu, then rotate the vertical() shift knob to make the picture taller or shorter, or rotate the horizontal () shift knob to make the picture wider or narrower. The amount of adjustment available depends on the selected output rate.

If a sizing limit has been reached, the LCD screen will display Min or Max.

System 7SC • Operation and Configuration 3-13

Page 41
Image 41
Extron electronic System 7SC manual Audio Level, Blank Input blanking adjustment, Image Size, Size Input