Operation and Configuration, cont’d
System 7SC • Operation and Configuration3-16Initiating IR learning

If an IR command from the display’s remote control has not already been

programmed into the System 7, a driver is unavailable, or an update is needed, IR

learning is the best, fastest way to load that command into the System 7. Use the

flowchart below as a guide to IR learning.

IR learning will automatically replace any old commands from the buttons you are

programming. If no IR signal is received by the System 7 during IR learning, the

previously stored IR commands are not cleared; they remain in that button’s

memory.

Initiating IR learning

Extron
System 7SC
AUDIO/VIDEO
ADJUSTMENTS
Input #1
Status: Clear
MENU
SWITCHER SETUP/
CONFIGURATION
MENU
NEXT
NEXT
Signal was not learned
Signal has been learned
2 seconds
Input #1
Learn?
Input #1
IR Learning!
Input #1
Retry!
Input #1
Status: Saved
MENU
IR LEARNING
CONFIGURATION
If the IR signal is not detected
by the System 7SC, after
3 cycles the switcher exits
IR learning and returns to the
button's status screen.
The LCD and the front panel button flash
every half second until the IR signal
is learned (up to 6 sec.).
Repeat all steps for each
button to be learned.
SYSTEM 7SC
IRDISPLAY
VOLUME
RXLEARN
TX
RX
ADJUST
1 2 3
4 5 6
7 8
0
9
Point the projector's
IR remote control
at the System 7SC's
IR Learn porthole.
Briefly press the
desired button on
the remote.