3-11System 7SC • Operation and ConfigurationEdge Smoothing

This feature smooths edges of objects in a picture by minimizing the differences

between pixels. The default setting is “Yes”.

Add Slave (slaving switchers)

To expand the capacity of the System 7SC to a total of up to 16 inputs, connect and

configure a slave switcher. A maximum of one Extron switcher can be used.

A slave cable, Extron part number 26-386-01, is required for the RS-232 connection,

and the slave’s video output must be connected to input 1 of the System 7SC.

See “Connecting and Slaving a Switcher” in chapter 2 for cabling instructions, and

see the following diagram.

RS-232
PROJ CONTROL
CONTACT CLOSURE
RELAY 1
IR TRANSPORT RELAY 2
12
DISPLAY PWR
SENSOR
IR COMM
RGB
H/HV
V
INPUTS
AUDIO IN
SCP/AAP CONTROL
OUTPUTS
RGB
Anaheim, CA
100
-
240
50/60 Hz
1.3A MAX.
1
LR
1LR
2LR
3LR
4LR
5LR
6LR
12345 ABCDEABCDE
67
EDCBAABCDEFGHIJ
FIXED VARIABLE
ABCDEEDCBAEDCBA
R
R-Y
G/Y
VID
H/HV
V
B/C
B-Y
R
R-Y
G/Y
VID
H/HV
V
B/C
B-Y
R
R-Y
G/Y
VID
H/HV
V
B/C
B-Y
R
R-Y
G/Y
VID
H/HV
V
B/C
B-Y
R
R-Y
G/Y
VID
H/HV
V
B/C
B-Y
R
R-Y
G/Y
VID
H/HV
V
B/C
B-Y
2 3 4 5 6
LR
AUDIO OUT

System 7SC Rear Panel

Slave Switcher

Rear Panel

Host
Computer
Slave Cable
Extron part
# 26-386-01
90-240 VAC, 50/60 Hz
FUSE: 250V, 400mA SLO-BLO
INPUTS INPUTS
531246
Computer DVD
VCR
These Extron switchers can be slaved to
the System 7SC:
• System 8 PLUS • SW4 AR MX HV
• System 10 PLUS • SW 6 AR MX HV

The System 7SC with a slaved switcher

After the slave switcher has been connected to the System 7 and both switchers are

powered on, select the input quantity (10, 8, 6, or 4 inputs) that corresponds to the

attached slave switcher from the Add Slave submenu of the Switcher Setup/

Configuration menu.

Autoselect #7 (front panel input automatic signal type selection)

The front panel input (input 7) accepts video and one audio input. Only one video

format and one audio port will be active at a time on the front panel.

The active input type (RGB, S-video, or composite video) can be specified via the

LCD menu, or, in autoselect mode, the System 7SC automatically detects the active

video signal and selects that signal type whenever input 7 is active/selected. The

lowest voltage level that can be detected by the switcher is 2.0 Vp-p.