RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 239
Selecting the Lamination Position Step Procedure
1The Lamination Position control allows you to adjust the horizontal position of
the PolyGuard Overlaminate. This control functions in the exact same fashion
as the Image Position controls, except only the horizontal position of the
overlaminate requires adjustment.
•To adjust the Lamination position, click on the Horizontal adjustment
arrows.
•To move the overlaminate more toward the card output side of the Printer,
enter a positive number.
•To move the overlaminate more toward the card input side of the Printer,
enter a negative number. (Note: The adjustment arrows point in the
direction the patch will move on the card. The maximum value for the
Horizontal adjustment is ±100 Pixels (10 Pixels = about .03"/.8mm).)
•To adjust the Vertical placement of the PolyGuard Overlaminate, click
Continued on the next page