FARGO electronic HDP820 Reviewing the Laminator Temperature Adjustment, Automatic Reset Whenever

RESTRICTED USE ONLY Fargo Electronics, Inc.

Reviewing the Laminator Temperature Adjustment

Term	Description	Reference
Laminator	To change the temperature of the	See the Using the Lamination
Temperature	Laminator, adjust its temperature through	tab (only with the Card
Adjustment	the Lamination tab within the Printer	Lamination Module) in Section
	Driver setup window.	5, page 238.
	• New Temperature Settings: Once
	adjusted, the new temperature
	settings will be sent down with the
	next print job along with the rest of the
	Printer Driver information. Before
	printing begins, the laminator will
	automatically adjust itself to the new
	temperature setting. (Note: This new
	temperature setting will remain
	programmed within the Printer until it
	is once again changed within the
	Printer Driver or until the Printer is
	turned OFF.)
	• Automatic Reset: Whenever the
	Printer is turned OFF, the laminator
	will automatically reset itself and
	return to its default temperature the
	next time the Printer is turned ON.
	(Note: Pressing the Lamination
	Module's or Printer's Cancel button or
	switching the Printer power OFF and
	ON both serve to reset the Laminator
	to its default temperature.)
	• Consistent Temperature: The
	temperature setting within the Printer
	Driver stays the same until it is
	changed.

HDP￿ 800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 47