3 6 Finalizing the Installation (for qualified installers only)
configuration is correct, yet the flames are lifting or ghosting, shut off gas to the fireplace and contact the dealer for information on remedying the problem.
!This fireplace has been tested at altitudes up to 8,000 feet. In this testing we have found that the fireplace, with its standard orifice, burns correctly with just an air shutter adjustment. If local codes require resizing the orifice, in the U.S.A. refer to ANSI 223.1, Appendix P, in Canada
!Failure to properly adjust the air shutter may lead to improper combustion and a safety hazard. Consult your dealer or installer if you suspect an improperly adjusted air shutter.
7Turn the flame adjust knob to its highest position - the flames should be approximately 12" tall. Check the flame on low position. The flames should burn off of each burner hole. If the heater does not work correctly, contact your dealer for a remedy.
8Install the faceplate.
!ACID WASH WARNING: Before installing the faceplate, make sure any masonry that has been treated with acid wash has been properly neutralized (this is used primarily with brick faces). Acid wash (muriatic acid) is used to remove excess mortar. If not properly neutralized with an ammonia solution, the plated face may develop a permanent tarnish when the acid evaporates over time. Contact your dealer if uncertain your facing has been properly neutralized.
Arch Faces | Architectural Faces | |
Artisan | FACE MOUNTING: | |
Faces Use: | ||
| The face has tabs that insert into slots on brackets | |
3/8" Wrench | attached to the fireplace. To remove, lift the face | |
and tilt it back. To install, tilt the face back and | ||
| ||
| insert the tabs into the slots. | |
Black & Gold |
| |
Faces Use: |
| |
Phillips |
| |
Screwdriver |
|
9Give this manual to the home owner and fully explain the operation of this heater.
Travis Industries | 4050114 | 1 0 0 - 0 1 1 4 9 |
