Operation3 7
Before You Begin
Warning: Read this entire manual before you use your new fireplace (especially the section "Safety Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily injury, or even death.
Warning: Do not operate appliance with the glass front removed, cracked or broken. Replacement of the glass should be done by a licensed or qualified service person.
Location of Controls - See explanation below
The pilot flame is located below the rear log.
An instruction card for operating the fireplace is attached to the inside of the fireplace here. Replace it for easy reference.
Open the access door to view the controls.
Gas
Control
Valve
Flame Adjust Knob
Gas Control Knob
BURNER | ON | IGNITER | OFF | HI |
|
| |||
|
| LO |
| |
|
|
|
| |
| OFF |
|
|
|
On/Off Switch | Pilot Igniter | Blower Knob |
|
|
BLOWER
Blower | Knob | This knob controls the speed of the internal convection blower that pushes the |
|
| heated air into the room. |
On/Off | Switch | This control is used to turn the fireplace on and off. |
Pilot Igniter | The pilot igniter is used only to start the pilot. When pressed, it sends an electrical | |
|
| charge to the pilot assembly. This creates a blue spark directly next to the pilot, |
|
| igniting the pilot flame. |
Gas Control Knob | This knob controls gas to the burner and pilot. There are three positions: ON, OFF, | |
|
| and PILOT. The indicator line is to the left of the knob. |
Flame Adjust Knob This knob controls the flame height from low ("LO") to high ("HI”). The indicator line is above the knob.
?If using a remote control or thermostat, the On/Off Switch must be left "ON". Turning the On/Off Switch "OFF" will keep the fireplace off always.
Travis Industries | 4050114 | 1 0 0 - 0 1 1 4 9 |
