Fluke 192, 199, 196 Displaying an Unknown Signal with Connect-and-View, Screen After an Auto Set

Fluke 192/196/199

Users Manual

Displaying an Unknown Signal with Connect-and-View™

The Connect-and-View feature lets the test tool display complex, unknown signals automatically. This function optimizes the position, range, time base, and triggering and assures a stable display of virtually any waveform. If the signal changes, the setup is automatically adjusted to maintain the best display result. This feature is especially useful for quickly checking several signals.

To enable the Connect-and-View feature, do the following:

1	Perform an Auto Set. AUTO appears at
	the top right of the screen.

The bottom line shows the range, the time base, and the trigger information.

The waveform identifier (A) is visible on the bottom right side of the screen, as shown in Figure 7. The input A zero icon (-) at the left side of the screen identifies the ground level of the waveform.

2	Press a second time to select the
	manual range again. MANUAL appears
	at the top right of the screen.

Figure 7. The Screen After an Auto Set

Use the light-gray RANGE, TIME and MOVE keys at the bottom of the keypad to change the view of the waveform manually.

12