Fluke 2635A user manual Setup File Procedures, Using Setup Store, SEtUP, StorE

Memory Card Operations 3

Setup File Procedures

Setup File Procedures

Perform the following procedures to LOAD, STORE, and ERASE memory card instrument configuration (SEtUP) files.

Using Setup Store

Perform the procedure in Figure 3-5 to save the current instrument configuration. The communication parameters: baud, parity, CTS, and echo, remain as set previously by the front panel controls or computer interface. The instrument automatically assigns the next sequential SEtxx file name. When SEt99 is reached, the instrument loops back to reuse previously assigned file names that have been erased or skipped over. To assign your own file name, use the up/down and left/right arrow keys when creating the file.

FILES	FILES
	Init
	StAt
	dir
	dAtA
	SEtUP
ENTER
	SEtUP
	ErASE
	StorE
	LOAd
ENTER
	StorE
	SEt99
	SEtxx
	SEt00
	SUrE
ENTER	yES
	no
ENTER	Typical
	Required

Selecting the SETUP mode. Press the FILES key to access the FILES menu. Press the up/down arrow keys until SEtUP is displayed, then press the ENTER key. The menu changes to SEtUP. If an error message appears, see Table 3-1.

Selecting the STORE mode. Press the up/down arrow keys until StorE is displayed in the SEtUP menu, then press the ENTER key. The menu changes to StorE and a file name is displayed.

Storing a SEtxx File. Record the displayed SEtxx file name, where xx represents an instrument-assigned number between 00 and 99 or use the up/down, left/right arrow keys to select the xx number. Press the ENTER key to store the file.

Overwriting a SEtxx File. If the xx number selected in the previous step is already assigned, the existing file will be overwritten with the new file. If this is desired, select yES then press the ENTER key. If no is selected, the procedure will terminate. If an error message appears, see Table 3-1.

op41f.eps

Figure 3-5. Using SETUP STORE to Save Configuration Files

3-9