Fluke 2635A user manual Memory Card Data Extraction, Path to OPEn DAtxx Menu

Front Panel Operations 2

Operating Modes

3/bAd is displayed (see Figure 2-16). Err4/bAd indicates the internal memory is full, saving only the most recent 75 scans. The new card is updated with the scans in memory.

Memory Card Data Extraction

Measurement data recorded onto a memory card can be read only by a PC running Starter or Logger applications software. If you want to have a copy of the measurement data when it is being recorded, connect a printer during scan operations (see Chapter 5, Printer Operation). If using a printer, verify the data destination is "both" (memory card/printer) (see Figure 5-3).

		SCAN
	SCAN ON		CH
SCAN
		0:00:00
	Path to
	OPEn
		OPEn
	dAtxx
	menu.
		dAtxx
		ENTER
		SCAN
	SCAN OFF
SCAN		- OFF -

Starting the Scan Mode. Press the SCAN key to start scanning. If the data destination includes the memory card and a data file has not been opened, a dAtxx file will be displayed. If an error message appears, refer to Figure 2-16.

Opening a Data (dAtxx) File. Press ENTER to open the suggested file or use the cursor keys to select a file name (00 to 99), then press ENTER. If an error message appears, refer to Figure 2–16. Press the CANCL key to exit without opening a file or starting scanning.

Stopping the Scan Mode. Press the SCAN key again to stop the scan mode (-OFF- will be displayed momentarily). If SCAN is pressed during the measurement interval, the measurements will be completed.

SHIFT

SCAN

SINGLE SCAN

SCAN

CH

0:00:00

Starting the Single Scan Mode. Press the SHIFT key then then SCAN key for a single measure-ment scan. If the data destination includes the memory card and a data file has not been opened, a dAtxx file will be displayed. If an

Path to OPEn dAtxx menu.

OPEn

dAtxx

ENTER

error message appears, refer to Figure 2-16.

Opening a Data (dAtxx) File. The suggested dAtxx file can be opened by pressing ENTER, or the cursor keys can be used to select a file name (00 to 99), then press ENTER. If an error message appears, refer to Figure 2-16. Press the CANCL key to exit without opening a file.

op27f.eps

Figure 2-15. Using the Scan Mode

2-27