Fluke Network Tester Setting Up and Connecting NetTool, Introduction, Configuring NetTool

Chapter 2

Setting Up and Connecting NetTool

Introduction

This chapter shows you how to set up NetTool. Among the tasks covered are how to set NetTool’s date and time, how to configure its IP address information, and how to locate important information, such as the serial number.

This chapter also shows you how to make a single-ended connection and an inline connection between NetTool and a network device.

Configuring NetTool

To configure NetTool, select the NetTool icon

The NetTool menu is displayed:

.

afq59s.bmp

Figure 2-1. NetTool Menu

Use this menu to access the tester’s setup menus, which are described in the following sections.

2-1