Fluke Network Tester Obtaining a Device’s IP Address Information, Addresses Used Screen

NetTool

Users Manual

Obtaining a Device’s IP Address Information

To obtain IP address information for a device, do the following:

1.Select Addresses Used to display the following:

2.CDP (Cisco Discovery Protocol) information, if found, is also given on this screen. Press the Down b arrow key to locate the CDP section, as shown in Figure 4-8:

ahn25s.bmp

Figure 4-7. Addresses Used Screen

The Addresses Used screen enables you to verify a devices’ IP address information. This screen also displays the best-discovered name for the device as well as its IP, IPX, and MAC address.

ahn323s.bmp

Figure 4-8. CDP Information

CDP information is reported for the most recently received CDP advertisement on that side. This information is updated every two seconds.

When plugged into a switch VLAN port, information for Native VLAN and Appliance (phone) VLAN are also given.

4-6