|
|
|
Configuring the FortiWiFi | NAT/Route mode installation |
Figure 7: NAT/Route mode connections
DMZ network
Web Server
DMZ
Router
Mail Server
Wireless network
WAN1
Internet
WAN2
MODEM / DSL / Cable | Internal |
Internal network
Configuring the networks
If you are running the FortiWiFi unit in NAT/Route mode, your networks must be configured to route all Internet traffic to the IP address of the interface where the networks are connected.
•For the internal network, change the default gateway address of all computers and routers connected directly to your internal network to the IP address of the FortiWiFi internal interface.
•For the DMZ network, change the default gateway address of all computers and routers connected directly to your DMZ network to the IP address of the FortiWiFi DMZ interface.
•For the WAN network, change the default gateway address of all computers and routers connected to your WAN network to the IP address of the FortiWiFi WAN interface.
•For the WLAN network, configure an IP address for the wireless local area network interface.
If you are using the FortiWiFi unit as the DHCP server for your internal network, configure the computers on your internal network for DHCP.
Make sure the connected FortiWiFi unit is functioning properly by connecting to the Internet from a computer on the internal network. You should be able to connect to any Internet address.
39 | |
