The FortiUSB key | FortiWiFi Firmware |
11Enter the firmware image filename and press Enter.
The TFTP server uploads the firmware image file to the FortiWiFi unit and messages similar to the following are displayed:
•FortiWiFi unit running v2.x BIOS
Do You Want To Save The Image? [y/n]
Type y.
•FortiWiFi unit running v3.x BIOS
Save as Default firmware/Run image without saving:[D/R]
12Type D.
The FortiWiFi unit installs the new firmware image and restarts. The installation might take a few minutes to complete.
Restoring the previous configuration
Change the internal interface address, if required. You can do this from the CLI using the following command:
config system interface edit internal
set ip <address_ipv4mask>
set allowaccess {ping https ssh telnet http}
end
After changing the interface address, you can access the FortiWiFi unit from the
For more information, see the FortiGate Administration Guide.
If you are reverting to a previous firmware version (for example, reverting from FortiOS v3.0 to FortiOS v2.80), you might not be able to restore your previous configuration from the backup up configuration file.
The FortiUSB key
The FortiUSB key provides flexibility and control when backing up and restoring configuration files. The FortiUSB key also enables you to have a single, secure location for storing configuration files.
The FortiUSB key is used with the USB
Note: The FortiUSB key is purchased separately. The FortiWiFi unit only supports the
FortiUSB key available from Fortinet.
72 | |
