Fostex PD-6 SETUP/UTILITY key, File SEL/EDL SEL key, TIME/DISP Mode key, Light key, Exit key

PD-6DVD Location Recorder (Chapter 3: Names and functions)

4.[SETUP/UTILITY] key

This key has primary (unSHIFTed) and secondary (SHIFTed) functions.

•When unSHIFTed:

Enters the Setup mode in which you can make settings for the preferences (see page 87). To exit from the Setup mode, press the [EXIT] key.

•When SHIFTed:

Enters the Utility mode in which you can make settings related with disks (see page 105). To exit from the Utility mode, press the [EXIT] key.

5.[FILE SEL/EDL SEL] key

This key has primary (unSHIFTed) and secondary (SHIFTed) functions.

•When unSHIFTed:

By pressing this key, you can selects an audio file from among the files recorded on the current disk using the [SEL] dial (see page 77). After selecting the file, pressing the [ENTER] key to confirm the setting.

•When SHIFTed:

Enters the EDL SEL mode. In this mode, you can create and edit an ALE file which should be registered during recording (see page 123). To exit from the EDL SEL mode, press the [EXIT] key.

6.[TIME/DISP MODE] key

This key has primary (unSHIFTed) and secondary (SHIFTed) functions.

•When unSHIFTed:

Selects the time display mode from among ABS, LTC, TC IN and GEN.

•When SHIFTed:

Switches to the mode in which you can enlarge the level display section on the screen (see page 44).

7.[LIGHT] key

Used to turn on the LCD backlight.

By pressing the key instantly, the LCD backlight turns on for approximately three seconds and then automatically turns off.

By pressing the key for more than three seconds, the backlight continues to light up until pressing the key again.

<Note>

While operating the PD-6 with the internal battery, we recommend not to turn on the backlight unless it is needed.

8.[EXIT] key

Used to cancel edit operation or execution, as well as used to exit the setup or Utility mode.

9.[SEL] dial/[ENTER] key

The [SEL] dial is used to select a menu or enter characters in the Setup mode and other editing modes.

The [ENTER] key confirms setting or executes the selected operation.

10.LCD display

Displays audio input/output levels, settings, menus, etc. (see page 43).

33