Soloing the REC BUSS OUT
VM200 User’s Guide
113
Soloing the REC BUSS OUT
You can solo the signal output from the REC BUSS by pressing the
REC BUSS
[SOLO]
key (located next to the Master
[SOLO]
key). The
Rec Buss
[SOLO]
key lights up. The Rec Buss
[SOLO]
key works only
when Solo mode is set to PFL, which is the default setting. If Solo
mode is set to M-Solo, the Rec Buss
[SOLO]
key is disabled. For more
information on Solo mode, see page 101.
If you set the Solo Key parameter to LATCH, pressing the Rec Buss
[SOLO]
key solos the stereo output until you press the Rec Buss
[SOLO]
key again. If the parameter is set to UNLATCH, the Rec Buss output
will solo only until you release the Rec Buss
[SOLO]
key.
Setting the REC BUSS OUT Level
You can set the Rec Buss output level on the
CURRENT SCENE STATUS
function page.
1.
Press the
[CURRENT SCENE STATUS]
key.
The VM200 displays the
CURRENT SCENE STATUS
function page.
2.
Rotate the EQ/HI Gain rotary control (channels 7/8) to adjust
the REC-B GAIN parameter.
The REC-B GAIN parameter controls the Rec Buss Out level.
REC BUSS
SOLO REC BUSS SOLO key