Fostex VM200 Monitoring and Soloing Input Channels, Feeding Outputs, REC Buss Out, ST Buss Out

Monitoring and Soloing Input Channels

2.Use the Page Select keys to select the target channel layer.

3.Press the [EQ EDIT], [SOLO], or [ON] key that represents the desired routing for the target channel.

See the following table:

KEY	TARGET ROUTING
EQ EDIT	ADAT DIRECT OUT
SOLO	REC BUS
ON	STEREO BUS

When you press an [EQ EDIT], [SOLO], or [ON] key, the key lights up and the corresponding indicator on the display turns dark (high- lighted). A light empty indicator means the routing is not selected (off).

If channels are configured as stereo pairs, their Routing switches are also linked. (For more information on pairing channels, see “Pairing Channels” on page 68.)

4.Press the [EXIT] key or the [CHANNEL/METER] key to return to Channel Edit mode.

Monitoring and Soloing Input Channels

For information on monitoring input channels, see “Monitoring Sig- nals” on page 97

Feeding Outputs

REC Buss Out

You can route input channels 1–20 to the Rec Buss outs. See “Using the REC BUSS OUT” on page 112 for more information.

ST Buss Out

You can route input channels 1–20 to the Stereo Buss outs. See “Using the ST BUSS OUT” on page 110 for more information.

AUX Sends

You can route input signals to Aux 1, 2, 3, or 4 by pressing the [AUX1], [AUX2], [AUX3], or [AUX4] key and raising the corresponding fader. (You can use Aux 3 and 4 when ADD. AUX mode is turned on.) You can also configure input channel sends as either pre-fader or post-fader. See “Using the AUX Sends” on page 115 for more information.

VM200 User’s Guide 67