Fostex VM200 manual Monitor Outs and Phones, Two Track Input 2TRK

Monitor Outs and Phones

pressing the [SOLO] key for the desired channel.

Two Solo modes are available: PFL (Pre-Fader Listen) and M–SOLO (Mix Solo).

See “Soloing” on page 101 for more information.

Monitor Outs and Phones

You can output Monitor and Solo signals via the MONITOR OUT and PHONES jacks.

Make sure the 2TRK IN switch is not pressed in for monitoring (unless you want to confidence monitor), or you will not hear a signal. (See 2TRK IN, below, for more information.)

You can connect a monitor system (amplifier and speakers) to the MONITOR OUT phono jacks on the rear panel. You can use the Mon- itor Gain control, located at the top right of the control surface, to adjust the level of the monitor out signal.

You can connect a pair of stereo headphones to the PHONES stereo (TRS) phone jack. The PHONES signal is the same as the MONITOR OUT signal. You can adjust the level of the phones signal using the Phones Gain control.

MONITOR Gain

MONITORPHONES

2TRK IN

GAINGAIN

MIN MAX MIN MAX

PHONES Gain (top panel}

Two Track Input (2TRK IN)

If you press the 2TRK IN switch on the top panel, you can monitor signals that are connected to the 2TRK IN jacks on the rear panel.

The signal is sent to the MONITOR OUT and PHONES jacks.

You can connect the stereo outputs of a master recorder, for exam- ple, to the 2TRK IN jacks for confidence monitoring or master play- back.

The 2TRK IN accepts phono jacks with a –10 dBV nominal input level.

MONITOR	PHONES		2TRK IN
	2TRK IN
GAIN	GAIN	R	L

2TRK IN switch

MIN MAX MIN MAX

2TRK IN jacks (rear panel)

VM200 User’s Guide 99