7-4: REPLACE TEMPERATURE PROBE (cont.)
11.Place the new temperature probe assembly onto the element and secure with the screws removed earlier. Clip the probe onto the rear of the element. The temperature probe assembly should be oriented in the same manner as the probe being replaced.
12.Thread the probe wires into the harness connector as removed in Step 7.
13.Lower the element into the frypot.
Secure probe to | New probe assembly |
element with metal Ty- | properly installed in tilt |
Wrap | plate |
|
|
14.Place the tilt housing cover over the tilt housing assembly and secure with screws
15.Install the top, center and bottom back covers and secure with screws.
Tilt housing cover in place
7-5: REPLACE HEATING ELEMENT
1.Perform Procedure
2.Remove the element wires from the connector. Press down on either side of the connector while pulling up on the top portion. The connector will open from the top. Pull all wires from the connector.
|
| Harness |
|
|
|
| Harness |
| |||||||||||||
| Connector |
|
|
| Connector |
| |||||||||||||||
|
| Closed |
|
|
|
|
| Open |
| ||||||||||||
|
|
|
|
|
|
|
|
|
| Top Portion |
| ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Push in on tabs to release
top portion
