Frymaster H14 Series Replace High-Limit, Place tool here when removing and installing high- limit

7-6: REPLACE HIGH-LIMIT

1.Perform Procedure 7-4, Replace Temperature Probe, Steps 1-4.

2.Disconnect the wire harness containing the high-limit wires.

3.Use a pin-pusher to remove the two high- limit wires from the wire harness connector. For split-pot fryers, remove only the wires for the high-limit to be replaced. Mark each wire for re-assembly.

4.Remove the high-limit from the frypot using an open-end wrench or other suitable tool.

5.Apply Loc-Tite PST 567 sealant to the replacement high-limit threads.

6.Screw the replacement high-limit into the frypot and tighten securely. DO NOT OVERTIGHTEN.

7.Insert the replacement high-limit wires into the proper pin-holes in the connector. The same two pin-holes from which the defective high-limit wires were removed.

8.Reconnect the wire harness connector.

9.Install and secure the back covers.

10.Position the fryer under the exhaust hood.

Use a pin-pusher to remove high-limit wires from connector

Pin Pusher— P/N 807-0928

Place tool here when removing and installing high- limit

7-9