Frymaster H14 Series service manual REPLACE TEMPERATURE PROBE cont

7-4: REPLACE TEMPERATURE PROBE (cont.)

6.Disconnect the wire harness containing the probe wiring. It may be necessary to remove the wire ties.

7.Use a pin-pusher to remove the probe wires from the connector. Mark each wire for re- assembly.

Use a pin-pusher to remove probe wires from connector

8.Remove the screw(s) securing the probe bracket to the element.

9.Thread the probe wire through the hole in the tilt plate assembly and remove the probe and the securing components from the element.

10.Remove the probe from the probe bracket. Place the new probe into the bracket.

Thread probe wire through hole in tilt plate assembly, them remove probe and components from element.

7-4